Differences

This shows you the differences between two versions of the page.

--- raspihandheld [2016/10/29 02:19] – [Display / HDMI] konstantin
+++ raspihandheld [2016/11/06 01:07] (current) – carlos
@@ Line 27: / Line 27: @@
 Der Expansionheader wird mit der "Hauptplatine" verbunden. Pin1 befindet sich an der "inneren" Seite des RasPi3, gegenüber der USB-Buchsen.
-Ersetzen durch : SSW-120-02-G-D-RA + TSW-120-08-G-D-RA
+Ersetzen durch : TLW-120-05-G-D
+Adapterplatine mit 2x SLW-120-01-G-D
 {{::raspbery-pi-3-gpio-pinout-40-pin-header-block-connector.png?500|}}
@@ Line 41: / Line 43: @@
 ===== Tastatur =====
-Samtec FC1-24-01-T Flachbandkabelbuchse
+Samtec ZF1-24-02-T-WT Flachbandkabelbuchse
 {{::jornada_720_keymap.jpg?600|}}
@@ Line 93: / Line 95: @@
 - Insert the SD card into the Raspberry Pi, connect ethernet, and apply 5V power.
-  Use the serial console or SSH to the IP address given to the board by your router.
+ Use the serial console or SSH to the IP address given to the board by your router.
-  Login as the default user alarm with the password alarm.
+ Login as the default user alarm with the password alarm.
-  The default root password is root.
+ The default root password is root.
+===== Touchscreen Calibration =====
+- Download [[https://aur.archlinux.org/packages/xinput_calibrator/|xinput_calibrator]]
+- Extract: <code> tar -xvf xinput_calibrator.tar.gz && cd xinput_calibrator </code>
+- Download or copy [[https://gitlab.unusproomnibus.de/snippets/2|PKGBUILD]] to extracted folder
+- Make package: <code> makepkg -cs </code>
+- Install: <code> sudo pacman -U $PKG </code>
+- Run calibration: <code> xinput_calibrator </code>